SVS-5MMF - 5 Meter (16.4 ft) Extension Cable

SVS-5MMF - 5 Meter (16.4 ft) Extension Cable
SVS-5MMF - 5 Meter (16.4 ft) Extension Cable
Item# SVS-5MMF
$45.00

SVS-5MMF - 5 Meter (16.4 ft) Extension Cable
This extension cable features a custom M14 Locking Mechanism with 4-pin mini-DIN male to female connectors, it measures 5 meters (16.4 ft.).

This cable is also available in 3 meter (9.8 ft., part SVS-3MMF) and 10 meter (32.8 ft., part SVS-10MMF) and can be adapted to connect to a standard 4-pin mini DIN with part SVS-25CM.

The M14 locking mechanism on the female-side 4-Pin Mini DIN connects to the M14 connector with the male 4-Pin Mini DIN connector on certain models of Safety Vision Cameras.

The M14 locking mechanism on the male-side 4-Pin Mini DIN has a nut that screws onto a female M14 receptacle on certain monitors and mobile digital video recorders (MDVRs) made by Safety Vision. The locking mechanism creates a tight fit, reducing the chances of the cable getting disconnected when installed on vehicles or other equipment that tend to vibrate.

The M14 male connector also features a rubber gasket with an "O-ring" to further isolate the signals from water or liquids; we can't say that is a "water-proof" cable, however, when properly connected it certainly reduces the chances of issues related to water or external use.

Note: The cable has several wires that are individually insulated and are covered by an outside jacket. This cable is commonly used for video and low-power equipment, such as cameras and monitors, on cars, trains, and planes.

Note: This cable is compatible with Safety Vision Cameras that have a male M14 connector; the M14 male connector is connected to the M14 female-side of this cable and thus you can extend the distance of the connection to the monitor or Mobile Digital Video Recorder (MDVR).

This cable is not compatible with our other locking connectors, since the diameter of the threaded connector is 14mm (M14) and other locking connectors use a 12mm (M12) connector. The outside diameter of the connector is 18mm, so you may need to drill a hole just bigger than 18mm in order to feed the cable through.

Note: It is not suggested you use this cable for S-Video applications, since the wires inside the cable are not wired for S-Video and do not have 75 ohm impedance.

Designed in Texas, made in the China. Harmonized Code 8544.42.00